|
|
|
| SM-42-1000 |
|
|
Installation Instructions
This Model For Surface Mounting Only. Extends Into Room Approximately 3".
- Determine desired ironing board height above floor using chart below. Care should be taken to insure unit will be mounted at ironing board height desired.
- Locate wall stud to be used for mounting. Stud should be located as close to center of cabinet as possible. Using a 1/4" drill bit predrill holes through upper and lower cross frames where ancoring screws will be located. (caution: Do not predrill wall with 1/4" drill bit. See Step D for wall instructions.)
- Allow at least 16" to side of cabinet for door to swing open. Door opens approximately 180 degrees.
- Using a 3/16" drill bit predrill a pilot hole into wall stud where cabinet will be attached to wall. (Caution: Table shows mounting height to bottom of cabinet.)
- Attach cabinet to wall by inserting lag screws included for mounting through predrilled holes in the cabinet cross frames or braces and screw into predrilled pilot holes in wall stud.
|
|
|
One-Year Limited Warranty...From date of purchase is replaced on all defective parts returned to factory for replacement, other than ironing board cover and pad, and finished or stained doors. This warranty does not include labor for installation of replacement. |
Mounting Height
Above Floor Level
|
|
|
|
Desired Board
Height
38"
37"
36"
35"
34"
33"
32"
31"
30"
29"
28"
|
Mount Cabinet
Above Floor
33"
32"
31"
30"
29"
28"
27"
26"
25"
24"
23"
|
